<![CDATA[SoliForum - 3D Printing Community — Settings to make support material easier to remove?]]> 2016-08-13T20:10:11Z PunBB https://www.soliforum.com/topic/15338/settings-to-make-support-material-easier-to-remove/ <![CDATA[Re: Settings to make support material easier to remove?]]> wardjr wrote:

Try going to the extrusion width settings screen and decrease the support extrusion width to a value close to half your nozzle diameter.

My support extrusion width is set at .25 with a .4 nozzel. But ill set it to .2 and see what happens

]]> https://www.soliforum.com/user/6367/ 2016-08-13T20:10:11Z https://www.soliforum.com/post/126202/#p126202 <![CDATA[Re: Settings to make support material easier to remove?]]> this one:

http://soliforum.com/i/?o8QWDoK.jpg

]]> https://www.soliforum.com/user/10399/ 2016-08-11T01:44:25Z https://www.soliforum.com/post/126069/#p126069 <![CDATA[Re: Settings to make support material easier to remove?]]> Try going to the extrusion width settings screen and decrease the support extrusion width to a value close to half your nozzle diameter.

]]> https://www.soliforum.com/user/2291/ 2016-08-10T13:41:04Z https://www.soliforum.com/post/126059/#p126059 <![CDATA[Settings to make support material easier to remove?]]> Greetings,
Sometimes my support material comes off easily and cleanly, but 8 out of 10 times its so hard to remove that I end up sanding it off with a dremel... I was wondering if this is normal and everyone has hard time removing support material or just my possible settings needs tweaking?

http://i.imgur.com/GtPGtnX.png

]]> https://www.soliforum.com/user/6367/ 2016-08-10T05:30:27Z https://www.soliforum.com/post/126048/#p126048