<![CDATA[SoliForum - 3D Printing Community — Barrel rotated under torque, no idea how to correct it!]]> 2016-07-23T22:14:46Z PunBB https://www.soliforum.com/topic/15161/barrel-rotated-under-torque-no-idea-how-to-correct-it/ <![CDATA[Re: Barrel rotated under torque, no idea how to correct it!]]> I've had mine rotate about that much.  I considered it too much of a pain to try to correct when it did not seem to affect my output.

]]> https://www.soliforum.com/user/3349/ 2016-07-23T22:14:46Z https://www.soliforum.com/post/125435/#p125435 <![CDATA[Re: Barrel rotated under torque, no idea how to correct it!]]> My brutish approach when that happened was to wire the motor in reverse and very slowly turn it back where it should be.

]]> https://www.soliforum.com/user/6745/ 2016-07-22T18:22:16Z https://www.soliforum.com/post/125368/#p125368 <![CDATA[Re: Barrel rotated under torque, no idea how to correct it!]]> 45 degrees is no problem, pellets will still feed.

]]> https://www.soliforum.com/user/221/ 2016-07-15T13:15:39Z https://www.soliforum.com/post/125105/#p125105 <![CDATA[Barrel rotated under torque, no idea how to correct it!]]> Hi there folks,

as per the title, the motor rotated the barrel by about 45 degrees, so now the feed hole is offset.

I've given it all the wrench I can muster, but cannot get it to rotate, any ideas?

[img]IMG_20160715_1204476.jpg[/img]

Thanks guys!

]]> https://www.soliforum.com/user/14803/ 2016-07-15T11:10:56Z https://www.soliforum.com/post/125100/#p125100