2016-07-10T02:16:24Z PunBB https://www.soliforum.com/topic/15129/hello-again-to-all/ Hello everyone. I Have a Stock SD3 the only upgrades and changes Ive made are the Power supply upgrade, added the glass plate, made the encloser,  and printed all the parts that i need to do the linear 8mm bearing carriage upgrades, & some basic Calibration(circles aren't oval) and extruding 100mms is accurate. everything i was working on had been put on hold since Late 2014. I Have the E3D V6 assembled, just waiting to be put to use. As of now the only thing i am missing is ordering replacement 8mm SS rods, so i am able to remove the OEM Setup and a whole unit.  from my understanding after i get the 8mm rods and red and blue wire connectors its just plug/tune PID settings & change the Speeds and Feeds? Correct? What i have not found out is what plugs into what. when doing upgrading the Hotend. Can someone Please Pm pictures or a install video if there is one for Carriage swap and Hotend Change...I know i am WAY BEHIDE everyone else...I am sorry to bring back old memories lol...Hope i am not asking to much...Thank in advance as always...

]]> https://www.soliforum.com/user/7496/ 2016-07-10T02:16:24Z https://www.soliforum.com/post/124913/#p124913