<![CDATA[SoliForum - 3D Printing Community — Filament hack]]> 2016-06-15T06:19:20Z PunBB https://www.soliforum.com/topic/14917/filament-hack/ <![CDATA[Re: Filament hack]]> Hello , you have explanations here http://neoprodfx.net/flashage-cartouche … -vinci-1-x

i use slic3r and change temperature with M commands

]]> https://www.soliforum.com/user/14577/ 2016-06-15T06:19:20Z https://www.soliforum.com/post/124172/#p124172 <![CDATA[Re: Filament hack]]> you are using 2.1.0 firmware and filament reset works? where can I get a copy of the arduino code? What slicing software are u using?

]]> https://www.soliforum.com/user/8318/ 2016-06-14T23:27:54Z https://www.soliforum.com/post/124163/#p124163 <![CDATA[Re: Filament hack]]> Hello, ,

I have the same version , i reset with the small arduino program and no problem. 240 m , the temperature is inoperant but i change it in the gcode file. it works .
best regards

]]> https://www.soliforum.com/user/14577/ 2016-06-13T14:52:28Z https://www.soliforum.com/post/124073/#p124073 <![CDATA[Re: Filament hack]]> Repetier, best filament hack there is !

]]> https://www.soliforum.com/user/6872/ 2016-06-07T04:31:27Z https://www.soliforum.com/post/123823/#p123823 <![CDATA[Filament hack]]> My 1.0a has 2.1.0 firmware on it. Haven't found any info regarding filament hack for this version.

Any suggestions.

Thanks

]]> https://www.soliforum.com/user/8318/ 2016-06-06T17:16:18Z https://www.soliforum.com/post/123791/#p123791