Do you know what version bootloader is in your board? It should be listed on the label on the chip as well as the original firmware version. There are if I recall three different bootloaders for that board and the flash process is different for each.
Is it somewhere on here? Or the back?
]]>28. Within the CMD window, navigate to the folder you unzipped the BootleaderHID to in step 23
29. Type “hid_bootloader_cli -mmcu=at90usb1286 -w -v Marlin.cpp.hex” (no quotations)
I dont even have a BootloaderHID zip because that URL doesnt work (http://blog.lincomatic.com/wp-content/) and the ones the other users gave me dont have a BootloaderHID zip anywhere.
]]>carl_m1968 wrote:The ino file needs to stay where it is when unpacked, that is what tells Arduino what to load for the sketch. You need to run the command line but alter it to point to the ino file.
huh...so then why are the instructions telling me to place the ino file into BootloaderHID folder...im so confused
Follow the instructions then, maybe your flash softwate is different. There are a few vesrsions depending on the original bootloader installed on the boatd.
]]>The ino file needs to stay where it is when unpacked, that is what tells Arduino what to load for the sketch. You need to run the command line but alter it to point to the ino file.
huh...so then why are the instructions telling me to place the ino file into BootloaderHID folder...im so confused
]]>use that link - click on "Download Zip", then extract the contents.
]]>I'm looking into that link now.
This is the website for the link:
http://www.soliwiki.com/Updating_Solido … structions
This is the link:
]]>