SoliForum - 3D Printing Community — Horrible Z Axis Grinding - Help?

Re: Horrible Z Axis Grinding - Help?

2018-09-10T09:15:43Z

sdiglesias wrote:

I upped the Z trimpot and it seems to have fixed it. I'm getting good prints now. I had set them to solidoodle's recommended voltages a while ago, but I guess it wasn't enough

have those voltages?

Re: Horrible Z Axis Grinding - Help?

2016-04-14T07:40:46Z

sdiglesias wrote:

I upped the Z trimpot and it seems to have fixed it. I'm getting good prints now. I had set them to solidoodle's recommended voltages a while ago, but I guess it wasn't enough

So what did you end up setting the trimpots to?

Re: Horrible Z Axis Grinding - Help?

2016-04-10T17:20:13Z

I upped the Z trimpot and it seems to have fixed it. I'm getting good prints now. I had set them to solidoodle's recommended voltages a while ago, but I guess it wasn't enough

Re: Horrible Z Axis Grinding - Help?

2016-03-30T02:19:09Z

In the stepper for the z-axis, there is a nut that should hold the rod in place, it has two holes in it for a tightening tool. I would suggest trying to tighten or loosen it. It could be that it's too loose and not getting appropriate purchase or too tight and causing binding. Another video that also shows what the top of the motor is doing could help diagnose this.
Another thought is there could be an issue with the anti-backlash that is causing binding. Grease it all up and see if it helps.

Also, if you reduce the travel speed, does it still grind?

Horrible Z Axis Grinding - Help?

2016-03-24T03:03:52Z

This started recently. I had just gotten the E3Dv6 working, then all my prints began starting high.

I am able to reliably get it to make horrible noises by doing G1 Z150 then G1 Z10:

(this was after homing x, y, and z)

Any help would be greatly appreciated!