<![CDATA[SoliForum - 3D Printing Community — Need help with print]]> 2013-02-25T04:36:54Z PunBB https://www.soliforum.com/topic/1436/need-help-with-print/ <![CDATA[Re: Need help with print]]> Just flip that and print it standing straight up.  You may have to change the front guard that holds in the battery to be at an angle (45 degrees or less) then you shouldn't need any support.

]]> https://www.soliforum.com/user/253/ 2013-02-25T04:36:54Z https://www.soliforum.com/post/13952/#p13952 <![CDATA[Re: Need help with print]]> kisslicer is supposed to have some of the best support structures and I have been extremely happy with the gcode it has been putting out.  You can load the gcode into RH easily as well.

http://kisslicer.com/

]]> https://www.soliforum.com/user/366/ 2013-02-24T18:04:18Z https://www.soliforum.com/post/13872/#p13872 <![CDATA[Re: Need help with print]]> jon_bondy wrote:
dubbsd wrote:

what settings do i need to set

Enabling Support will work, but then the situation is somewhat out of your control.  Another option would be to modify the object being printed so that there are some small supports that you design in yourself.  Then you can just snap them off after the object prints.  Having control over the support material can be useful.

I don't care for Slic3rs support. I prefer the supports generated by skeinforge myself.

]]> https://www.soliforum.com/user/7/ 2013-02-24T15:10:01Z https://www.soliforum.com/post/13831/#p13831 <![CDATA[Re: Need help with print]]> dubbsd wrote:

what settings do i need to set

Enabling Support will work, but then the situation is somewhat out of your control.  Another option would be to modify the object being printed so that there are some small supports that you design in yourself.  Then you can just snap them off after the object prints.  Having control over the support material can be useful.

]]> https://www.soliforum.com/user/181/ 2013-02-24T15:05:21Z https://www.soliforum.com/post/13828/#p13828 <![CDATA[Re: Need help with print]]> Check generate support material under print settings in slic3r.  Happy printing!

]]> https://www.soliforum.com/user/614/ 2013-02-23T23:48:19Z https://www.soliforum.com/post/13787/#p13787 <![CDATA[Need help with print]]> I am printing with an SD3 using the recomended Repeiter - host ver. 0.82b & slic3r
and as you can tell be the pic the top has no support and will not print wright

what settings do i need to set
Thanks in advance

]]> https://www.soliforum.com/user/187/ 2013-02-23T23:18:51Z https://www.soliforum.com/post/13786/#p13786