SoliForum - 3D Printing Community — re: repetier .92 davinci 10.A

Re: re: repetier .92 davinci 10.A

2016-03-20T17:14:20Z

Thanks Carl for the reply
so i don't understand i have made changes to temp and x& y home cordinates to print in the center of the bed and did not have to disable anything are you saying i have to make the changes in the firmware and then re-flash the E-prom

Thanks

Re: re: repetier .92 davinci 10.A

2016-03-19T23:39:13Z

jamerfut wrote:

Hi Guy's
I am trying to calibrate my 10. A printer running repetier .92 so i am adjusting the steps per MM and printing a 10 mm x 10mm x 10 MM square cube and no matter what i make the setting's in the step per mm it dosen't change the size of the cube any help on this is greatly appreciated
Thanks

You have to disable the EEPROM storage in the firmware or open Repetier host and make your changes in the EEPROM window. By default Repetier firmware stores your initial settings in EEPROM if you don't disable the setting before flashing.

Once stored those values will override all other values in the firmware.

re: repetier .92 davinci 10.A

2016-03-19T20:33:13Z

Hi Guy's
I am trying to calibrate my 10. A printer running repetier .92 so i am adjusting the steps per MM and printing a 10 mm x 10mm x 10 MM square cube and no matter what i make the setting's in the step per mm it dosen't change the size of the cube any help on this is greatly appreciated
Thanks