SoliForum - 3D Printing Community — re: repetier .92

Re: re: repetier .92

2016-03-21T19:24:48Z

Thanks for the reply then it looks like my printer is about as good as i can get it.

Re: re: repetier .92

2016-03-20T18:13:09Z

depends on the plastic. I usually print a 20 mm calibration cube and my last pla one was 19.98 x 19.89 which really is about right on

Re: re: repetier .92

2016-03-20T17:19:24Z

Thanks for the reply
Ok so how close a tolorence can the davinci print a part + 1 MM to - 1 MM is this as good as it can do.

Thanks

Re: re: repetier .92

2016-03-20T01:06:24Z

Also, a 10mm cube is too small of an object to calibrate. If you're just printing 1 small cube at a time, that cube is probably beyond deformed by heat. I think you're chasing the wrong tail here.

Re: re: repetier .92

2016-03-20T01:03:08Z

The printer is running on fixed tooth belt and pulley. The prefixed values are correct and should never be adjusted. If you're getting dimensional inaccuracies, you need to calibrate your extrusion rate, extrusion width and filament diameter. Measure your filament carefully in multiple spots. It's almost never exactly 1.75mm. The particular brand that I use is always around 1.71mm. My extrusion rate is set to .95 and my extrusion width is .48.

re: repetier .92

2016-03-19T20:28:47Z

Hi Guy's
I am trying to calibrate my 10. A printer running repetier .92 so i am adjusting the steps per MM and printing a 10 mm x 10mm x 10 MM square cube and no matter what i make the setting's in the step per mm it dosen't change the size of the cube any help on this is greatly appreciated

Thanks