<![CDATA[SoliForum - 3D Printing Community — can not get computer to communicate ?]]> 2016-02-27T21:21:51Z PunBB https://www.soliforum.com/topic/14138/can-not-get-computer-to-communicate/ <![CDATA[Re: can not get computer to communicate ?]]> try setting the com port to a higher number in device manager (properties > advanced settings), then select that port in arduino and see if that helps

also make sure you have the correct board selected in arduino

]]> https://www.soliforum.com/user/10399/ 2016-02-27T21:21:51Z https://www.soliforum.com/post/118158/#p118158 <![CDATA[can not get computer to communicate ?]]> Hi, I just got done building a M one Prime and I am using a ramps 1.4 setup.
I can not seem to get arduino to communicate with my ramps?  I have good spare ramps board so I tried that and still nothing?
Not sure where to start? its says my com3 port is in use.  I have disable and re enabled com3 still nothing. same error.

]]> https://www.soliforum.com/user/7268/ 2016-02-27T21:08:44Z https://www.soliforum.com/post/118157/#p118157