<![CDATA[SoliForum - 3D Printing Community — Having Issues with Repetier Software and the Davinci 1.0A]]> 2016-02-24T23:39:07Z PunBB https://www.soliforum.com/topic/14085/having-issues-with-repetier-software-and-the-davinci-10a/ <![CDATA[Re: Having Issues with Repetier Software and the Davinci 1.0A]]> ABS is normally in the 235 range. Your image however is what happens when the base of your print comes free and the printer then just prints in the air. So your bed adhesion and maybe first layer quality is bad.

]]> https://www.soliforum.com/user/7731/ 2016-02-24T23:39:07Z https://www.soliforum.com/post/117836/#p117836 <![CDATA[Re: Having Issues with Repetier Software and the Davinci 1.0A]]> Is it possible that the Extruder Temp I am using is incorrect?  I am using 200c with Standard Davinci ABS Filament 1.75...  Bed Temp of 110.

-Sal-

]]> https://www.soliforum.com/user/13760/ 2016-02-24T22:16:03Z https://www.soliforum.com/post/117824/#p117824 <![CDATA[Re: Having Issues with Repetier Software and the Davinci 1.0A]]> Looks like poor bed adhesion. Adjust your nozzle height properly and use glue stick.

]]> https://www.soliforum.com/user/7731/ 2016-02-24T19:34:04Z https://www.soliforum.com/post/117790/#p117790 <![CDATA[Having Issues with Repetier Software and the Davinci 1.0A]]> I am having some bizarre problems with my DaVinci Printer after installing the Repetier Firmware.  I am sure that it is some type of configuration problem...  Just not sure where to begin in correcting the issue.  Please look at image attached.

-Sal-

]]> https://www.soliforum.com/user/13760/ 2016-02-24T16:08:00Z https://www.soliforum.com/post/117739/#p117739