<![CDATA[SoliForum - 3D Printing Community — ABS adhesion to PVA support Material]]> 2016-02-08T23:07:51Z PunBB https://www.soliforum.com/topic/13674/abs-adhesion-to-pva-support-material/ <![CDATA[Re: ABS adhesion to PVA support Material]]> Ive duct taped every crack the case has and set the first layer speed to 50%.  That helps.  .12mm is about as thin as you can reliably go.

]]> https://www.soliforum.com/user/10400/ 2016-02-08T23:07:51Z https://www.soliforum.com/post/116124/#p116124 <![CDATA[ABS adhesion to PVA support Material]]> Hello,

I am trying to print a model that needs support and I am using PVA for the support. 98% of my 1st layer of the model is going over the PVA support.  My problem is that the model edges are curling and will not adhere to the PVA. Has anyone figured out how to correct for this situation?

Specifics: Davinci 2.0 (dual extruders), with Repetier firmware, slic3r.   1.75 Candy Yellow extruder temp 225c, and PVA extruder temp 185c

I have searched all over and have not found a remedy.
Thank you In advance for any assistance.

]]> https://www.soliforum.com/user/13556/ 2016-02-08T23:00:30Z https://www.soliforum.com/post/116123/#p116123