<![CDATA[SoliForum - 3D Printing Community — Slicer printing out of the bed?]]> 2013-02-18T03:16:18Z PunBB https://www.soliforum.com/topic/1352/slicer-printing-out-of-the-bed/ <![CDATA[Re: Slicer printing out of the bed?]]> And yeah, I'm using Windows 7 smile

]]> https://www.soliforum.com/user/887/ 2013-02-18T03:16:18Z https://www.soliforum.com/post/13070/#p13070 <![CDATA[Re: Slicer printing out of the bed?]]> Hi!

I installed that one, and before i installed the Solidoodle All in one package available at the SDd site ( i cant post links)

I was researching with my machine, and I noticed that sometimes the Y axis stops moving in one direction - it gives the echo endstop even when its not at the end.

Then I found a google groups thread talking that this might happen because of the belts not being aligned



However, this thread is about the SD2, and I am not sure if that might be the cause of the errors i'm experiencing sad

Any help with this would be greatly appreciated, i was so excited about this printer and i am not  able to print with it.

]]> https://www.soliforum.com/user/887/ 2013-02-18T03:15:45Z https://www.soliforum.com/post/13069/#p13069 <![CDATA[Re: Slicer printing out of the bed?]]> Did you d/l the software from the link at solidoodle.com --->  http://dl.dropbox.com/u/90605134/setupR … e_0_82.exe

just guessing you are using the windows system???

Also check out here --> http://solidoodletips.wordpress.com/201 … tier-host/

]]> https://www.soliforum.com/user/296/ 2013-02-17T05:42:59Z https://www.soliforum.com/post/12988/#p12988 <![CDATA[Slicer printing out of the bed?]]> Hi!

I just received the brand new SD3, the issue i have is that, when I use the Repetier package to produce the gcode and load it to print, even whne i center the piece, it tries to print it outside of the bed,

Is this an issue of the SD not knowing were the origin is? if so, how could i fix it?

]]> https://www.soliforum.com/user/887/ 2013-02-17T01:30:13Z https://www.soliforum.com/post/12975/#p12975