SoliForum - 3D Printing Community — Filastruder from Italy

Re: Filastruder from Italy

2016-01-26T20:31:48Z

PTFE is used because it is lower friction than aluminum, so the filament slides over it more easily.

2016-01-26T20:25:47Z

Thank you Rev, may be that an aluminium one could be better?

2016-01-26T18:34:59Z

^ this guy is correct!

2016-01-26T18:16:51Z

I don't have a 2.0 model but I believe the PTFE tube would go in the T shaped slot in front of the fan where the filament touches the wood case.

2016-01-26T17:45:45Z

elmoret wrote:

Looking good!
If you have problems with kinking, you might want to slide that fan mount back a bit and put the PTFE tube in the slot.

Hi Tim,

I'm sorry I haven't understood which is the slot to put the PTFE tube.
Can you send a picture.

Regards

2016-01-25T02:20:15Z

Cool bottle and nice assembly.

2016-01-24T19:13:22Z

Looking good!

If you have problems with kinking, you might want to slide that fan mount back a bit and put the PTFE tube in the slot.

2016-01-24T11:50:11Z

Hi everybody,

I send a picture of a working Italian Filastruder

Best regards from Italy