<![CDATA[SoliForum - 3D Printing Community — New Products]]> 2017-02-27T19:07:30Z PunBB https://www.soliforum.com/topic/13401/new-products/ <![CDATA[Re: New Products]]> Good to see you again active in the Davinci world !

The glass / heater I got from you still works great !

Konrad

]]> https://www.soliforum.com/user/6745/ 2017-02-27T19:07:30Z https://www.soliforum.com/post/133139/#p133139 <![CDATA[Re: New Products]]> It is sold out, where can I find this?

]]> https://www.soliforum.com/user/12290/ 2017-02-23T01:49:56Z https://www.soliforum.com/post/132945/#p132945 <![CDATA[Re: New Products]]> No worries you're all good smile

]]> https://www.soliforum.com/user/2/ 2016-01-15T21:11:54Z https://www.soliforum.com/post/114198/#p114198 <![CDATA[New Products]]> I've been away from the Forum for a while. Life has a way of directing your attention and at times it can't be ignored. Anyway..

A few people had trouble when installing the glass that I sell.
Seems the power supply on the DaVinci 1.0 series is marginal for the printer and when installing my glass/ heater it would trip the PSU off when powering up. The combination of extruder, heated bed and steppers would pull too much power and cause the PSU to shut down.

I know one solution is to install a higher watt PSU but it requires cutting and splicing wires as well as you're left with a lot of wires that aren't used.

In response to this problem I've developed a Plug N Play solution using a 350watt power supply.http://soliforum.com/i/?lunU2Fi.jpg

I'm in the middle of torture testing now and they should be available next week.

Of course I have to add a link to the site where it can be purchased. www.davincizone.com

If I've offended anyone or broken any rules, please let me know and I will remove this.

Regards,
James

]]> https://www.soliforum.com/user/7397/ 2016-01-14T19:42:52Z https://www.soliforum.com/post/114128/#p114128