<![CDATA[SoliForum - 3D Printing Community — How to re-center the extruder vs the build plate.]]>2016-01-14T23:19:38ZPunBBhttps://www.soliforum.com/topic/13398/how-to-recenter-the-extruder-vs-the-build-plate/<![CDATA[Re: How to re-center the extruder vs the build plate.]]>Bingo - Learned something new today. -7 was the fit. Think the offset comes from a modified extruder moving the nozzle.
Again - Thanx!
Ski
]]>https://www.soliforum.com/user/3790/2016-01-14T23:19:38Zhttps://www.soliforum.com/post/114140/#p114140<![CDATA[Re: How to re-center the extruder vs the build plate.]]>I'll give it a shot...
Thanx
]]>https://www.soliforum.com/user/3790/2016-01-14T22:51:25Zhttps://www.soliforum.com/post/114138/#p114138<![CDATA[Re: How to re-center the extruder vs the build plate.]]>Measurement with trial and error. It looks like the Y is off about 10mm. Put a bed front offset of -10. If that makes it worse, try +10. You could print a cube of known size, stop it after the first layer and then measure the distance to the front of the bed with your calipers before removing the print. Then do the math to get more precise.]]>https://www.soliforum.com/user/4377/2016-01-14T21:10:08Zhttps://www.soliforum.com/post/114131/#p114131<![CDATA[How to re-center the extruder vs the build plate.]]>I know the commands are there - Bed Left, Bed Front, etc., I just don't know how to use them. This is what I got...]]>https://www.soliforum.com/user/3790/2016-01-14T17:55:52Zhttps://www.soliforum.com/post/114117/#p114117