<![CDATA[SoliForum - 3D Printing Community — Thinking about doing something crazy with my DaVinci 1.0.]]> 2016-01-12T23:04:32Z PunBB https://www.soliforum.com/topic/13378/thinking-about-doing-something-crazy-with-my-davinci-10/ <![CDATA[Re: Thinking about doing something crazy with my DaVinci 1.0.]]> I'm  thinking on putting a rumba board in my 1.0a.  It's only $68 bucks and has 6 steppers with the good drivers.  It also has screw terminals. I'm still dickering with XYZ on buying a replacement board for it, but they want a $100 and my old board.. Haven't heard back from them for a few days,, thinking I should just go ahead and start cutting things over.. The Rumba has the option to use thermistors or thermacouples   I believe.

]]> https://www.soliforum.com/user/8779/ 2016-01-12T23:04:32Z https://www.soliforum.com/post/113984/#p113984 <![CDATA[Re: Thinking about doing something crazy with my DaVinci 1.0.]]> Carl is your man for this.
At least I'm sure he fitted a ramps board to a Davinci anyway.

]]> https://www.soliforum.com/user/6872/ 2016-01-12T19:40:07Z https://www.soliforum.com/post/113957/#p113957 <![CDATA[Thinking about doing something crazy with my DaVinci 1.0.]]> I got my DaVinci 1.0 way back in August of 2014 and used it almost non stop till February of 2015 when I go my Flashforge Creator Pro. Since then I don't use the DaVinci as much. I was thinking about modding it and replacing the motherboard with a Mighty Board
http://www.flashforge-usa.com/shop/part … board.html I know I will need to replace the end stops and the hot end. But I should be able to use the stepper motors. I will also replace the heated bed with a better one. I would like to install the Sailfish firmware on it.

Just wandering if this will work or would it be a wast of time?


Link to board fixed.

]]> https://www.soliforum.com/user/7347/ 2016-01-12T14:14:24Z https://www.soliforum.com/post/113936/#p113936