<![CDATA[SoliForum - 3D Printing Community — Nice infographic for beginners]]> 2013-02-24T15:48:57Z PunBB https://www.soliforum.com/topic/1333/nice-infographic-for-beginners/ <![CDATA[Re: Nice infographic for beginners]]> nickythegreek wrote:

Ian just posted a link in another thread to RepRap Magazine Issue #1 which has a slicer comparison in it as well. I haven't checked this out yet.

http://reprapmagazine.com/

Nice article!

]]> https://www.soliforum.com/user/7/ 2013-02-24T15:48:57Z https://www.soliforum.com/post/13845/#p13845 <![CDATA[Re: Nice infographic for beginners]]> Ian just posted a link in another thread to RepRap Magazine Issue #1 which has a slicer comparison in it as well. I haven't checked this out yet.

http://reprapmagazine.com/

]]> https://www.soliforum.com/user/366/ 2013-02-22T21:59:35Z https://www.soliforum.com/post/13664/#p13664 <![CDATA[Re: Nice infographic for beginners]]> cmetzel wrote:

http://www.3ders.org/articles/20130215- … eprap.html

They make the process a little more complex than it has to be.

]]> https://www.soliforum.com/user/7/ 2013-02-22T16:50:34Z https://www.soliforum.com/post/13600/#p13600 <![CDATA[Re: Nice infographic for beginners]]> Ian did a good breakdown on this temp difference here:

http://solidoodletips.wordpress.com/201 … mperature/

]]> https://www.soliforum.com/user/366/ 2013-02-21T23:07:34Z https://www.soliforum.com/post/13526/#p13526 <![CDATA[Re: Nice infographic for beginners]]> The layout of each printer and hot end is slightly different.  If the thermister is not in precisely the same location as the heating element on both printers, the reported temperatures will differ from the actual by different amounts.

]]> https://www.soliforum.com/user/181/ 2013-02-21T17:33:37Z https://www.soliforum.com/post/13473/#p13473 <![CDATA[Re: Nice infographic for beginners]]> DePartedPrinter wrote:

keep in mind the suggested temps will not work with a SD...

Why is that? Is there an error in how either the SD or RepRap temperature?

]]> https://www.soliforum.com/user/504/ 2013-02-21T15:36:10Z https://www.soliforum.com/post/13459/#p13459 <![CDATA[Re: Nice infographic for beginners]]> keep in mind the suggested temps will not work with a SD...

]]> https://www.soliforum.com/user/55/ 2013-02-15T18:59:34Z https://www.soliforum.com/post/12881/#p12881 <![CDATA[Nice infographic for beginners]]> http://www.3ders.org/articles/20130215- … eprap.html

]]> https://www.soliforum.com/user/78/ 2013-02-15T15:00:44Z https://www.soliforum.com/post/12859/#p12859