SoliForum - 3D Printing Community — Finally assembling early backer kit - Ribbon cable troubles?

Re: Finally assembling early backer kit - Ribbon cable troubles?

2016-01-05T16:17:05Z

Once elmoret explained what the cable looked like, I was able to track it down in my 'parts bin' (thankfully, I didn't toss it out).

The scanner is up and running. Now for all the fun calibration. Thanks for your help, gang!

Re: Finally assembling early backer kit - Ribbon cable troubles?

2016-01-05T12:24:24Z

StickC,

You should have also received a cable like the one below. Please recheck the contents of the kit to make sure you didn't miss it. If you can't find it, send me a message via Kickstarter.

Thanks,
Uriah

Re: Finally assembling early backer kit - Ribbon cable troubles?

2016-01-04T04:54:36Z

Perhaps from Uriah/Murobo, but I'd probably just file down the edge of the ribbon cable.

Re: Finally assembling early backer kit - Ribbon cable troubles?

2016-01-04T04:41:47Z

Ahh. Is there a place to source that version of the cable? This is what I received. (Note how the grey header interferes with the pins, preventing it from seating fully).

Re: Finally assembling early backer kit - Ribbon cable troubles?

2016-01-04T04:26:17Z

The kits currently ship with a 40 pin header that only has a 26pin cable on it.

Finally assembling early backer kit - Ribbon cable troubles?

2016-01-04T03:49:24Z

I got one of the Atlas 3D kits many many months ago via Kickstarter. I got derailed after printing all the pieces and am finally getting a chance to put it together. I printed the case to fit a Raspi B+. I'm running into an issue with the ribbon cable fitment and was wondering what the best solution is.

I'm trying to use a Raspi2, which has a 40 pin GPIO header (I think the Raspi B+ has the same header). The Atlas controller board only has a 'standard' 26 pin ribbon cable (grey with red 'pin1 indicator'). As far as I know, the first 26 pins have the same signals regardless of board, but the size of the ribbon cable header interferes with the additional pins on the Pi's header, so I can't actually seat it.

What's changed in newer kits to support the B+/2? Is the Atlas board connector now 40pin? I'm not sure a 40 pin cable would fit through the opening without folding. The assembly video seems to show a small cable with a Raspi B+ or 2.