SoliForum - 3D Printing Community — SD3 & Simplicity3D: What would cause Extrusion and XY to stop working?

Re: SD3 & Simplicity3D: What would cause Extrusion and XY to stop working?

2016-01-05T03:25:46Z

In the AM I will connect with RH and see if it can run the XY and Extruder. If so, I know the problem is in Simplify3D.

Re: SD3 & Simplicity3D: What would cause Extrusion and XY to stop working?

2016-01-04T20:56:19Z

Uh, no it's still not right actually.

Re: SD3 & Simplicity3D: What would cause Extrusion and XY to stop working?

2016-01-04T19:04:33Z

After setting oernight, yon printer awakes. It's X and it's Y and it's E a delight for all to see.

Re: SD3 & Simplicity3D: What would cause Extrusion and XY to stop working?

2016-01-04T02:59:30Z

I completely neglected to mention the filament got pinched in the cover and caused the motor to grunt while it pulled against it as it tried to move to the farthest corner of the bed. I immediately shut off the printer. Since then, the XY & E don't respond except when I HOME.

SD3 & Simplicity3D: What would cause Extrusion and XY to stop working?

2016-01-04T02:47:34Z

I thought at first it was the setting to "Wait until temp stabilizes" but I unchecked that and it still won't go. In the Control Panel, I am Jogging the extruder and XY but they don't respond. Likewise, in the Bed Leveling Wizard, I click Begin (it Homes) then Next and nothing happens.

I have restarted printer, PC, Simplicity3D, still no cigar.