<![CDATA[SoliForum - 3D Printing Community — Fix for: DaVinci 1.0 error 0014 (Extruder temp stuck at 10C)]]> 2016-01-03T08:15:41Z PunBB https://www.soliforum.com/topic/13268/fix-for-davinci-10-error-0014-extruder-temp-stuck-at-10c/ <![CDATA[Re: Fix for: DaVinci 1.0 error 0014 (Extruder temp stuck at 10C)]]> Well done !
Had a similar problem recently but in my case, the yellow thermistor wire had been badly damaged after a short. I got low temps and the def error.
Had to replace the wire all the way to the main board but all is well now.

]]> https://www.soliforum.com/user/6872/ 2016-01-03T08:15:41Z https://www.soliforum.com/post/113138/#p113138 <![CDATA[Fix for: DaVinci 1.0 error 0014 (Extruder temp stuck at 10C)]]> So I spend hours in despair probing my new 3D printer with a multimeter since it displayed an "Error 0014"

But I'm so happy because
I found out how to fix it

Here's how to troubleshoot it:

  • Check connectors on extruder

  • Open back panel. Check connectors on the motherboard.

  • Check thermistor resistance for responsiveness with a multimeter. Room temp should be 100k ohms.
    Refer to this chart to check the temp based on resistance: http://www.bapihvac.com/content/uploads … r_100K.pdf

In my case there was just a loose connector at the back panel where the motherboard is. I was reluctant to open it thinking it would void my warranty. But I'm so happy I did open that panel! Connector was probably dislodged during shipping. http://soliforum.com/i/?H1Kd4Fe.jpg

This saved me so much time and money. And when I fixed it I was jumping and screaming.
So proud to do this at 16 years old. smile

]]> https://www.soliforum.com/user/13133/ 2016-01-03T05:09:28Z https://www.soliforum.com/post/113130/#p113130