<![CDATA[SoliForum - 3D Printing Community — Upgrade a 1.0 to a 2.0 Duo?]]> 2015-12-25T18:42:58Z PunBB https://www.soliforum.com/topic/13177/upgrade-a-10-to-a-20-duo/ <![CDATA[Re: Upgrade a 1.0 to a 2.0 Duo?]]> well yes and no.
they are the same board but the 1.0 does not have the hardware installed to control the extruder. so unless you have a way of soldering in all the missing electronics (which it being surface mount is not easy).  it would be easier to put in a ramps 1.4 or Rambo board.

]]> https://www.soliforum.com/user/10955/ 2015-12-25T18:42:58Z https://www.soliforum.com/post/112562/#p112562 <![CDATA[Upgrade a 1.0 to a 2.0 Duo?]]> Just thinking about this, I think its possible to do.

The printer is physically the same as far as the case and framing; the 1.0 has the same frame as the 2.0 does, only difference is the dual head, slightly wider bed, firmware, and a little bit of wiring.

My only question is: Are the motherboards the same but with different firmware or are they actually different?

Any thoughts on this?

]]> https://www.soliforum.com/user/9216/ 2015-12-25T15:40:25Z https://www.soliforum.com/post/112547/#p112547