<![CDATA[SoliForum - 3D Printing Community — Cant get the print head to print on the bed its way to high]]> 2015-12-17T05:28:16Z PunBB https://www.soliforum.com/topic/13111/cant-get-the-print-head-to-print-on-the-bed-its-way-to-high/ <![CDATA[Cant get the print head to print on the bed its way to high]]> Hello,

I have run calibration tests but the print nozzle is way to far above the bed.  its probably floating a good 1/4 to half inch higher than it should be to print. 

How can I fix this? 

I ran z calibration and its currently set to 3.0  but that didn't seem to do anything at all. 

The probe is dropped down and just floating a smidge above the glass plate and wont retract when printing starts.


Whats going on?  Totally lost here.

]]> https://www.soliforum.com/user/12833/ 2015-12-17T05:28:16Z https://www.soliforum.com/post/111861/#p111861