<![CDATA[SoliForum - 3D Printing Community — Issue with one area of bed..]]> 2015-12-11T22:42:13Z PunBB https://www.soliforum.com/topic/13072/issue-with-one-area-of-bed/ <![CDATA[Re: Issue with one area of bed..]]> when it does it, it sort of seems like it's moving forward and to the right.  it's like only during diagonal movements.  that's my impression.

]]> https://www.soliforum.com/user/12492/ 2015-12-11T22:42:13Z https://www.soliforum.com/post/111396/#p111396 <![CDATA[Re: Issue with one area of bed..]]> Sounds like the wiring harness may have a break or a short. Is it just in one axis or both that its jumping around?

]]> https://www.soliforum.com/user/10955/ 2015-12-11T21:56:34Z https://www.soliforum.com/post/111393/#p111393 <![CDATA[Issue with one area of bed..]]> See the attached image.  For some reason when my carriage hits the general area marked in red, the carriage sort of has a seizure, and jumps around.  That, of course, screws up the print.  It seems if I print the model in the green area, it's just fine (or as fine as this stupid Da Vinci is ever going to be, but I digress...)

Any ideas?  I've aligned the belts. I replaced a broken bearing mount.  Oh... and it also randomly hits the center back wall when trying to go back to the home position and just hammers it.  I have to power it off, move the carriage, then send it back home again.
What gives??  Grrrr...

Thanks.

-Craig

]]> https://www.soliforum.com/user/12492/ 2015-12-11T19:52:56Z https://www.soliforum.com/post/111392/#p111392