<![CDATA[SoliForum - 3D Printing Community — SD3 startup problems]]> 2013-02-11T00:29:23Z PunBB https://www.soliforum.com/topic/1305/sd3-startup-problems/ <![CDATA[Re: SD3 startup problems]]> Oh, I see the lower left thin curved line part.... you may have to either slow down the feedrate on the first layer or turn on brim both settings are in slic3r print settings tab, or raise the bed temp up 98-100C as that is a pretty long thin line. one other thing you could do is move the 'z' screw up just a teensy bit so it smashes the first layer just a little bit more.

]]> https://www.soliforum.com/user/296/ 2013-02-11T00:29:23Z https://www.soliforum.com/post/12454/#p12454 <![CDATA[Re: SD3 startup problems]]> part of the first layer lefts off the bed

]]> https://www.soliforum.com/user/187/ 2013-02-11T00:21:55Z https://www.soliforum.com/post/12451/#p12451 <![CDATA[Re: SD3 startup problems]]> So... are you saying that the first layer is not sticking when the printer starts a new layer on top of it?

]]> https://www.soliforum.com/user/296/ 2013-02-11T00:20:48Z https://www.soliforum.com/post/12450/#p12450 <![CDATA[SD3 startup problems]]> Running windows 8
I loaded the repetier - host that is required for the SD3
adjusted the bed (Bed is Warped) to .015" at the screwsor it hits in the middle
the first delaminated and part of it came off the bed.
the layer thickness if the part s .020" to .025"

bed temp: 95
extruder: 195

See Picture

]]> https://www.soliforum.com/user/187/ 2013-02-11T00:07:22Z https://www.soliforum.com/post/12449/#p12449