SoliForum - 3D Printing Community — X axis homing issue

Re: X axis homing issue

2015-12-05T17:13:59Z

Yep just happy you got it fixed.

Re: X axis homing issue

2015-12-05T16:57:43Z

Ok after taking the switch out and testing everything I couldn't find anything wrong, I put back together and everything's working fine somehow. Must have been a loose connection somewhere:) Thanks for your help.

Re: X axis homing issue

2015-12-05T02:35:01Z

The X stop switch seems to be working just fine. But the problem still persists.

Re: X axis homing issue

2015-12-05T01:34:18Z

Yep use a continuity tester or a DMM. Unplug it from the board and test for continuity at the plug with the switch triggered there should be no continuity and with the switch not depressed there should be continuity.

Re: X axis homing issue

2015-12-04T23:44:55Z

Hmm the wires all look good. Is there any way to see if its making connection to the computer for sure?

Re: X axis homing issue

2015-12-04T23:21:18Z

Sounds like the X axis endstop has a loose connection or broken wire.

X axis homing issue

2015-12-04T23:09:00Z

Hi, after letting my Press sitting in the corner for a while the x axis isn't homing. The extruder doesn't move to the right(toward the x stop) at all, instead when I try to home the x axis it moves about 10 mm to the left then stops! Then it sets that as home. I was able to move it to the right with the manual control. So I tried turning of the printer and moving the extruder manually to the end stop, then I started it up and pressed home all, after moving to the left and popping down the probe it set that place as home for the x axis, keeping it from moving back to the center to home the z. I'm using Repetier Host and I've also tried using Matter Control. I've re-flashed the firmware but no success. Any help would be very appreciated.