<![CDATA[SoliForum - 3D Printing Community — Printing Taulman 910]]> 2015-11-24T18:58:45Z PunBB https://www.soliforum.com/topic/12918/printing-taulman-910/ <![CDATA[Re: Printing Taulman 910]]> Played w/ Cura start gcode and this is my solution.

; Default start code
G28 ; Home extruder
G92 Z-9.525  ; reset the position
G1 Z15 F{Z_TRAVEL_SPEED}
M107 ; Turn off fan
G90 ; Absolute positioning
M82 ; Extruder in absolute mode
{IF_BED}M190 S{BED}
; Activate all used extruder
{IF_EXT0}M104 T0 S{TEMP0}
G92 E0 ; Reset extruder position
; Wait for all used extruders to reach temperature
{IF_EXT0}M109 T0 S{TEMP0}

Will have to play w/ gcode position to get the correct nozzle Ht, that way when PLA is used , no bed adjust required.

]]> https://www.soliforum.com/user/7700/ 2015-11-24T18:58:45Z https://www.soliforum.com/post/110181/#p110181 <![CDATA[Printing Taulman 910]]> Ive read the best way to stick Nylon is using a phenolic sheet on the build platform.

I have a piece of 3/8" thick phenolic. This will change the bed height.
Instead of readjusting the bed level screws, what is the best way to adjust Z height thru software or firmware ?
I dont see anything in Curaengine to do this. Or is there ?

Slicr3 has a setting, Z offset, under printer settings. Not very inclined to use Slicr3, but is this another way ?

]]> https://www.soliforum.com/user/7700/ 2015-11-24T17:29:44Z https://www.soliforum.com/post/110176/#p110176