<![CDATA[SoliForum - 3D Printing Community — DaVinci 1.0 not loading filiament]]> 2015-11-03T04:05:02Z PunBB https://www.soliforum.com/topic/12709/davinci-10-not-loading-filiament/ <![CDATA[Re: DaVinci 1.0 not loading filiament]]> galaxy99 wrote:

Sounds like the nozzle is plugged and keeping plastic from flowing - thus, it blocks feeding filament.
This happens on my DaVinci 1.0A when the extruder wires lose connection (the two white wires/black connector on print head). I replaced the connector and no longer have the problem...
Remove the head / nozzle and clean it out (it needs to be hot to clean and a little butane torch and drill works...

Ok thanks. I will give it a try tomorrow and post the results.

]]> https://www.soliforum.com/user/8314/ 2015-11-03T04:05:02Z https://www.soliforum.com/post/108795/#p108795 <![CDATA[Re: DaVinci 1.0 not loading filiament]]> Sounds like the nozzle is plugged and keeping plastic from flowing - thus, it blocks feeding filament.
This happens on my DaVinci 1.0A when the extruder wires lose connection (the two white wires/black connector on print head). I replaced the connector and no longer have the problem...
Remove the head / nozzle and clean it out (it needs to be hot to clean and a little butane torch and drill works...

]]> https://www.soliforum.com/user/9607/ 2015-11-02T16:11:45Z https://www.soliforum.com/post/108683/#p108683 <![CDATA[DaVinci 1.0 not loading filiament]]> The two spinning gears that pull the filament through are no longer working. They do a quarter turn and stop, over and over again.

I tried searching through these forums, but the XYZ section isn't the most organized. Any help would be greatly appreciated.

]]> https://www.soliforum.com/user/8314/ 2015-11-02T14:55:47Z https://www.soliforum.com/post/108676/#p108676