SoliForum - 3D Printing Community — Best temperature and first few layers

Re: Best temperature and first few layers

2013-02-12T19:05:30Z

I am using the default retraction settings for a SD3. I was able to fix the fatter bottom layers by adjusting my bed height. On 1mm prints the strands are much better than at 3mm.

Re: Best temperature and first few layers

2013-02-08T05:44:18Z

In theory the hotter the plastic is the better it bonds but going too hot makes it runny. I usually print the first layer at 195 then go down to 185 for the rest of the layers.

As for the strings thats a retraction issue. What are you using for retraction settings?

Best temperature and first few layers

2013-02-06T21:05:15Z

I just got my SD3 yesterday and so far things have been pretty good. I do have a quick few questions that I think that someone here can easily answer.

1. The first few layers are a little wider than the rest (very minimal). I'm trying to print something that is pretty precise and was wondering if there is anything I can do to fix this. Would making my temperature hotter or cooler help or could it be that the z axis is slightly out of alignment.

2. From some of the prints that I have done (and others that I have seen on here) there have been a few strands of plastic that go from one point to another. What is the best thing that can be done to minimize these? Would this be a temperature issue, a retraction issue, or both?

Thanks