SoliForum - 3D Printing Community — SD4 carriage upgrade - screw sizes & idlers?

Re: SD4 carriage upgrade - screw sizes & idlers?

2015-10-23T21:10:29Z

2 to 3 mm

Re: SD4 carriage upgrade - screw sizes & idlers?

2015-10-23T20:51:05Z

wardjr wrote:

Everything is m3 except the y idler those are m5 I'm pretty sure if not its m4. Ace is the place so just grab both. You can measure the length needed for the Y but the others just grab varying lengths you'll need them all

any idea on the length of the grub screws?

Re: SD4 carriage upgrade - screw sizes & idlers?

2015-10-23T20:33:10Z

Everything is m3 except the y idler those are m5 I'm pretty sure if not its m4. Ace is the place so just grab both. You can measure the length needed for the Y but the others just grab varying lengths you'll need them all

SD4 carriage upgrade - screw sizes & idlers?

2015-10-23T18:43:40Z

so i'm going to be upgrading to lawsy's carriages soon, but it seems some of the screws for my SD4 are stripped, namely the left Y-idler, and the head of the left grub screw for the toothed gear for the left Y belt (on the jackshaft? driveshaft? not sure which is proper term).

so besides finding out the right sizes & sources for those (and from measuring the right y-idler shoulder bolt, they seem to be $6+ each!!), i assume i just need a lot of M3 bolts in various lengths? i've got a home depot & an ace hardware nearby, and mcmaster carr has a distro hub about 45 minutes away for pickup, and there's a couple small fastenal stores nearby.

going from belts to spectra line at the same time, anything else i should swap or consider upgrading while the X/Y is torn apart? maybe change out the Y-idlers since the tension adjust will be on the carriages?

TLDR: SD4 Y-idler bolt size, SD4 grub screw sizes, what specialty m3 lengths & specialty bolts/machine screws need?