SoliForum - 3D Printing Community — End to Filament issues? 'Pro' now being advertised

Re: End to Filament issues? 'Pro' now being advertised

2015-10-26T23:36:11Z

Not going to EVER buy a printer for XYZPrinting again, you could get an even better, and not to mention Open Source printer for just a few hundred bucks more. And now there are a bunch coming out a little cheaper then XYZPrinting's and are Open Source.

Re: End to Filament issues? 'Pro' now being advertised

2015-10-19T00:00:09Z

To me the Pro just looks like a supersized Jr. if that is the case then it will have issues like the Jr. and may even be locked into the RF tag scheme the Jr. uses.

Re: End to Filament issues? 'Pro' now being advertised

2015-10-18T21:19:11Z

If i didn't just buy the Duo i would have gone for this one .... There is a lot of bad reviews on the Davinci but my experience so far has been good ... It worked straight out of the box and these Pro's look even better

Re: End to Filament issues? 'Pro' now being advertised

2015-10-18T19:37:41Z

http://us.xyzprinting.com/us_en/Product … ofessional

Control over heat, third party filament, wifi, aluminum print bed... and a laser engraver.

Looks like they are paying some attention to what a customer wants.

Re: End to Filament issues? 'Pro' now being advertised

2015-10-18T18:00:43Z

evanalmighty wrote:

For what it's worth Makerbots are made in New York and they are just about the worst 3D printers you can buy for the money.

Yup, exactly right. I almost kicked one of their boxes at Fry's

Re: End to Filament issues? 'Pro' now being advertised

2015-10-18T17:54:02Z

For what it's worth Makerbots are made in New York and they are just about the worst 3D printers you can buy for the money.

Re: End to Filament issues? 'Pro' now being advertised

2015-10-18T15:56:23Z

AndyTake2 wrote:

Does this mean what I think it means? they are actually going to allow what everyone wants and needs? and will there be the software/firmware to allow temperature adjustments etc?

It's probably true, but I would not ever buy from XYZ Printing again. I mean, it's not made in the USA, it's made in Thailand. Most of it's parts are cheap. The printers are great, it's good to get your feet wet with these printers, but I would not invest in them as your 3d printer supplier.
Just my thoughts about it...

End to Filament issues? 'Pro' now being advertised

2015-10-18T12:00:31Z

I'm a complete newbie, and am looking for issues I have with my newly bought AiO.
One of the issues I continually read about is that of filament proprietary cartridges, and related subjects.
I have just visited the XYZ support site (Stop laughing!) and I just happened to click on the store button.

They now have the following listed:

http://us.store.xyzprinting.com/preorder/daVinciPro

The banner advert states 'daVinci 1.0 Pro ......Open Filament Source'

Does this mean what I think it means? they are actually going to allow what everyone wants and needs? and will there be the software/firmware to allow temperature adjustments etc?