<![CDATA[SoliForum - 3D Printing Community — Feature requests: WiFi network config UI, Disable Camera LED]]> 2015-10-11T15:30:39Z PunBB https://www.soliforum.com/topic/12524/feature-requests-wifi-network-config-ui-disable-camera-led/ <![CDATA[Re: Feature requests: WiFi network config UI, Disable Camera LED]]> Solid, please open Issues on the Github site so that progress on your suggestions can be tracked properly.

https://github.com/hairu/freelss


Uriah

]]> https://www.soliforum.com/user/4789/ 2015-10-11T15:30:39Z https://www.soliforum.com/post/107381/#p107381 <![CDATA[Re: Feature requests: WiFi network config UI, Disable Camera LED]]> What LED are you talking about?  The one on the Raspberry Pi itself? 

I think if the camera isn't detected, the FreeLSS program will not load.  I believe I ran into that problem when the camera ribbon cable pulled out of the connector on my Raspberry Pi.

]]> https://www.soliforum.com/user/10176/ 2015-10-10T22:12:59Z https://www.soliforum.com/post/107343/#p107343 <![CDATA[Feature requests: WiFi network config UI, Disable Camera LED]]> It would be nice if the UI would allow specifying the SSID for connecting to non-broadcast networks.

The LED is bright enough through the clear-printed case that the camera detects the red light reflecting off a target and distorts the 3D map.  It can be disabled in a config file but it would be better to have a switch in the UI.

The web UI loading should not be dependent on camera detection, it should load regardless so that the user isn't troubleshooting a network connection when it is really the camera.

]]> https://www.soliforum.com/user/12268/ 2015-10-10T16:29:10Z https://www.soliforum.com/post/107325/#p107325