<![CDATA[SoliForum - 3D Printing Community — Could you diagnose this result?]]>2015-09-29T11:28:48ZPunBBhttps://www.soliforum.com/topic/12414/could-you-diagnose-this-result/<![CDATA[Re: Could you diagnose this result?]]>batmaster wrote:
that edge is probably where the extruder either leaves or enters the part between features and because your temperature is too high its leaving ooze.
Ok, then I have to set a bit down the extruder temperature, currently 230ºC
Thanks!!
]]>https://www.soliforum.com/user/12134/2015-09-29T11:28:48Zhttps://www.soliforum.com/post/106467/#p106467<![CDATA[Re: Could you diagnose this result?]]>EDIT - sorry it double posted]]>https://www.soliforum.com/user/11030/2015-09-28T20:48:03Zhttps://www.soliforum.com/post/106430/#p106430<![CDATA[Re: Could you diagnose this result?]]>that edge is probably where the extruder either leaves or enters the part between features and because your temperature is too high its leaving ooze.]]>https://www.soliforum.com/user/11030/2015-09-28T20:47:56Zhttps://www.soliforum.com/post/106429/#p106429<![CDATA[Re: Could you diagnose this result?]]>Yes, it seems that. But only affecting an edge section?]]>https://www.soliforum.com/user/12134/2015-09-28T19:12:00Zhttps://www.soliforum.com/post/106426/#p106426<![CDATA[Re: Could you diagnose this result?]]>Temprature is too high.]]>https://www.soliforum.com/user/7731/2015-09-28T18:14:49Zhttps://www.soliforum.com/post/106415/#p106415<![CDATA[Could you diagnose this result?]]>What is wrong to obtain that edge?
