SoliForum - 3D Printing Community — Da Vinci 1.0 stated maximum build size not possible

Re: Da Vinci 1.0 stated maximum build size not possible

2015-09-24T10:26:47Z

Surely if the specifications list the build size as 20cm it should be able to do so.

One would think but reality is not often true. SD Has a build plate of 8" square but the numbers in the software are 200mm ^2

the folger tech delta has a n 8" diameter build plate but the build area is only 6 " diameter.
metal suppliers will often tell you the tolerance on a 1 foot piece is + - 1/8.
Tin

Re: Da Vinci 1.0 stated maximum build size not possible

2015-09-24T00:06:31Z

Well not to defend them but in theory you could reach that volume of your objects base was smaller then got larger as the layers went up. So yes 200 by 200 would be achievable as long as the base of the object fit between the glass hold downs.

Of course your going to find many more problems down the road with your purchase choice and XYZ's warranty. There are many mods you will probably want to do as you will go and see some of the short comings. I had one and liked it but it needs some work to get it printing really well.

Re: Da Vinci 1.0 stated maximum build size not possible

2015-09-23T23:57:24Z

I understand the issues with bed temp at the outer edges, but a stated size should be achievable. A 300mm rule is 300mm long, not 280mm.

Second post has been deleted. Trigger happy newbie :-)

Re: Da Vinci 1.0 stated maximum build size not possible

2015-09-23T23:49:30Z

Even if the build size is specified as 200 you would never actually go out to 200. The temp around the edge of the bed will be lower than the middle and average print of area of about 150mm. You could maybe push 180mm but even then it is iffy. Are they false advertising? Could be, depends on how they and others define build area. This is the case with most printers. You never want to use the full size of the bed as it can lead to adhesion and lifting issues along the edge of your print. At least this has always been my findings. Could be just bad bed design as well.

Also only one post is needed. So you might want to go back and delete the extra.

Da Vinci 1.0 stated maximum build size not possible

2015-09-23T23:45:21Z

I am trying to print to the maximum build size of 20cm x 20cm (200mm x 200mm) on the table, but the print head hits the four screws that hold the glass in place.

I have measured the actual travel head possible in the Y axis between the screws and it is only about 19.3cm (193mm). Has anyone else experienced this?

Surely if the specifications list the build size as 20cm it should be able to do so.