SoliForum - 3D Printing Community — repetier question

Re: repetier question

2015-09-23T22:50:53Z

Check out this thread over at Voltivo, I especially like the stat and ending scripts that Luc posted in the 2nd post in that thread.

http://voltivo.com/forum/davinci-softwa … de-scripts

Re: repetier question

2015-09-22T16:26:23Z

That did the trick, thank you.

Re: repetier question

2015-09-21T05:50:10Z

Go to FFF settings, click on the Scripts tab and add these 2 lines to the Ending Script

G1 Z200
G28 X0 Y0 ;move X/Y to min endstops so the head is out of the way

Re: repetier question

2015-09-21T01:37:52Z

Tin Falcon wrote:

check and see if the park after print job option is checked.
also what slicer are you using seems like cura parks sli3r did did not.
tin

He uses simplify3d . It has a built in slicer.

Re: repetier question

2015-09-21T01:36:50Z

using simplify 3D, sliccer is in it...

Re: repetier question

2015-09-21T01:33:50Z

check and see if the park after print job option is checked.
also what slicer are you using seems like cura parks sli3r did did not.
tin

repetier question

2015-09-21T01:28:25Z

I flashed my 1.0A a week ago and love it. I use simplify 3D and before the flash ( I always use the usb print option) when the print was done, X and Y were going back home and the bed was going all the way down. Now when the print job is done, all axis just stop at the last print point. How can I get the original behavior back?
P.S. I don't know nothing about g-code
Thx in advance.