SoliForum - 3D Printing Community — layer print issues

Re: layer print issues

2015-09-11T13:27:39Z

So I monitored the temperature and didn't see any shift in temp. I replaced the nozzle neck and I am receiving a new nozzle today I might try. I lowered speeds and still have the same problems with any model I print. About an inch above the print I start to get lower extrusion amounts and this causes issues with the layer splits. It doesn't make sense that it is happening at a certain point.

Oh yea I calibrated my printer as well. For some reason I feel like the extrusion rate is low. But my s3d settings are a little higher than normal for extrusion rates.

.20 nozzle tip with .38 thickness and 1.10 multiplier
.10 layer height thickness.
15-20% infill
3 shells

I've never had to use a fan with PLA either so maybe layers aren't cooling? But I don't know why I would need a fan now?

Re: layer print issues

2015-09-05T12:06:49Z

Okay thanks. My fear was that there could be various issues. Looks like I'll have to burn through 1kg of filament to figure this out lol.

Re: layer print issues

2015-09-05T01:29:39Z

Could be temperature drop. Filament acts as a heatsink and some more so than others. Could be print speed at the temp you are trying to print at. Could be a partial clog. Could be bad filament. Even the best can mess up a batch.

Re: layer print issues

2015-09-05T00:57:21Z

anyone have any ideas what would cause this?

layer print issues

2015-09-04T13:15:28Z

I'm running an mk9 extruder with SS pla filament. I was printing fine for months and recently I've had layer issues. I printed a gargoyle and the first 100ish layers were fine. As the print got higher it seemed as though some layers were not extruding properly.