<![CDATA[SoliForum - 3D Printing Community — Quick question about my prints. Can't get my e3d working properly]]> 2015-08-30T13:49:48Z PunBB https://www.soliforum.com/topic/12176/quick-question-about-my-prints-cant-get-my-e3d-working-properly/ <![CDATA[Re: Quick question about my prints. Can't get my e3d working properly]]> Thank you. I ll try this and post the results

]]> https://www.soliforum.com/user/8264/ 2015-08-30T13:49:48Z https://www.soliforum.com/post/104494/#p104494 <![CDATA[Re: Quick question about my prints. Can't get my e3d working properly]]> 4mm is way too much retraction. Did you use E3D's assembly instructions to assemble it? They state:

Excessively long retractions will cause issues by dragging soft filament into cold areas. E3D-v6 hotends need less retraction than most hotends. For direct extrusion systems you should use anywhere from 0.5mm-1.0mm, for bowden systems you might want to go up to 2mm. Retraction beyond 2mm is likely to cause issues.

http://wiki.e3d-online.com/wiki/E3D-v6_Assembly

]]> https://www.soliforum.com/user/221/ 2015-08-29T18:10:27Z https://www.soliforum.com/post/104449/#p104449 <![CDATA[Re: Quick question about my prints. Can't get my e3d working properly]]> It is 48. Sorry my bad. I tried 42 just in case if it would solve this problem.
Extrusion width is 48

]]> https://www.soliforum.com/user/8264/ 2015-08-29T17:19:09Z https://www.soliforum.com/post/104444/#p104444 <![CDATA[Re: Quick question about my prints. Can't get my e3d working properly]]> Did you buy a .35 nozzle? I didn't think so, try calibrating to .48 for the .4 nozzle.  Then worry about your other settings like retraction.

]]> https://www.soliforum.com/user/2291/ 2015-08-29T12:50:54Z https://www.soliforum.com/post/104436/#p104436 <![CDATA[Re: Quick question about my prints. Can't get my e3d working properly]]> And my top solid layers have sticking problem as well.
Thank you a lot for all the help in advance.

]]> https://www.soliforum.com/user/8264/ 2015-08-29T12:46:28Z https://www.soliforum.com/post/104435/#p104435 <![CDATA[Quick question about my prints. Can't get my e3d working properly]]> Hi guys,
Finally got my e3d working but i have a small issue.
I have been using my stock extruder with this filament and didnt have this problem.
Every layer has these dots. It happens on layer change. It might be about retraction.
Retraction is 4 and the retraction speed is 40.
I tried more retraction like 9 amd it got worse. Maybe i should try smaller retraction setting.
It is 3mm layer height with 0.42 extrusion width

]]> https://www.soliforum.com/user/8264/ 2015-08-29T12:45:41Z https://www.soliforum.com/post/104434/#p104434