<![CDATA[SoliForum - 3D Printing Community — Fireman Figurine - From Scan to Print]]> 2015-08-22T04:58:17Z PunBB https://www.soliforum.com/topic/12121/fireman-figurine-from-scan-to-print/ <![CDATA[Re: Fireman Figurine - From Scan to Print]]> it's 166mm, or about 6.5" tall

]]> https://www.soliforum.com/user/1357/ 2015-08-22T04:58:17Z https://www.soliforum.com/post/104016/#p104016 <![CDATA[Re: Fireman Figurine - From Scan to Print]]> Great work! What is the size?
Layer settings would also help understand resolution in relation to the size.

Again, spectacular job. I wish I had the time to work on my Atlas (at software stage), so I'm living vicariously wink

]]> https://www.soliforum.com/user/4188/ 2015-08-22T04:40:52Z https://www.soliforum.com/post/104014/#p104014 <![CDATA[Fireman Figurine - From Scan to Print]]> Here is a print of a Warren Stratford figurine.

This is one of a few Stratford figurines I have scanned using the Atlas 3D scanner.  As I have mentioned in my post in the Atlas section the scanning process isn't perfect, but with a little bit of work, you can end up with a model that is very close to the original.

Here is the print of the Fireman next to the original.  It was printed in 2 halves @ .1mm.  Sliced with Cura, support generated by Meshmixer.  No retouching was done, only the supports were removed.

http://www.soliforum.com/misc.php?action=pun_attachment&amp;item=9100

]]> https://www.soliforum.com/user/1357/ 2015-08-22T04:14:07Z https://www.soliforum.com/post/104013/#p104013