SoliForum - 3D Printing Community — Using Newer Repetier 1.5.4 ?

Re: Using Newer Repetier 1.5.4 ?

2015-08-24T03:21:10Z

Running fine here.

Re: Using Newer Repetier 1.5.4 ?

2015-08-24T01:49:08Z

As the ole adage goes, If it aint broke dont fix it. Everythings dialed in, so Ill stick w/ previous version.

But, yea, supports suck. Ill use B9 Creator, if not satisfied then, Ill place them manually. Havent tried Craftware.

Re: Using Newer Repetier 1.5.4 ?

2015-08-21T04:26:09Z

Did any of you guys notice a improvement in the slicing with support structures, especially the grid type? I was thinking of upgrading if possible.

Re: Using Newer Repetier 1.5.4 ?

2015-08-21T00:47:32Z

I have been using it just fine as well.

Re: Using Newer Repetier 1.5.4 ?

2015-08-19T17:17:27Z

i use 1.5.4 works fine.

Re: Using Newer Repetier 1.5.4 ?

2015-08-19T01:13:30Z

knucklbustr wrote:

Still using 1.06 w/ CuraEngine slicer. Get near perfect prints, though I run it slow, 25mm/s.
I see 1.5.4 is using a newer CuraEngine.
Anyone changed to the newer update ? Any noticeable improvements ?

I think most Da Vinci users are moving to Simplify3d simply because the reults are worth the price and it supports the Da Vincis directly.

Using Newer Repetier 1.5.4 ?

2015-08-19T01:01:05Z

Still using 1.06 w/ CuraEngine slicer. Get near perfect prints, though I run it slow, 25mm/s.

I see 1.5.4 is using a newer CuraEngine.

Anyone changed to the newer update ? Any noticeable improvements ?