<![CDATA[SoliForum - 3D Printing Community — Power Question]]> 2015-07-31T20:42:27Z PunBB https://www.soliforum.com/topic/11929/power-question/ <![CDATA[Re: Power Question]]> carl_m1968 wrote:

For a Da Vinci it would not be good. If you unplug power while the switch is on the power supply will pulse several times. These pulses may or may not be the correct voltage and could damage the very hard near impossible to find a replacement for motherboard.

Thanks.  I was half expecting for something like that to happen.

]]> https://www.soliforum.com/user/8750/ 2015-07-31T20:42:27Z https://www.soliforum.com/post/102615/#p102615 <![CDATA[Re: Power Question]]> For a Da Vinci it would not be good. If you unplug power while the switch is on the power supply will pulse several times. These pulses may or may not be the correct voltage and could damage the very hard near impossible to find a replacement for motherboard.

]]> https://www.soliforum.com/user/7731/ 2015-07-31T18:33:24Z https://www.soliforum.com/post/102597/#p102597 <![CDATA[Power Question]]> I have a wireless switch that I was thinking of hooking up my da vinci to so I can turn it on and off remotely.  I would leave the printer on and the switch would essentially unplug the printer when I turn it off.  Would this harm my printer or would it be ok?

]]> https://www.soliforum.com/user/8750/ 2015-07-31T18:13:57Z https://www.soliforum.com/post/102592/#p102592