<![CDATA[SoliForum - 3D Printing Community — WARNING: Firmware unresponsive]]> 2015-07-27T18:18:07Z PunBB https://www.soliforum.com/topic/11880/warning-firmware-unresponsive/ <![CDATA[Re: WARNING: Firmware unresponsive]]> ah ok thx ...

]]> https://www.soliforum.com/user/11160/ 2015-07-27T18:18:07Z https://www.soliforum.com/post/102154/#p102154 <![CDATA[Re: WARNING: Firmware unresponsive]]> Netfabb repairs parts but this may not be the problem

]]> https://www.soliforum.com/user/9677/ 2015-07-27T18:09:00Z https://www.soliforum.com/post/102153/#p102153 <![CDATA[Re: WARNING: Firmware unresponsive]]> netfabb it's better than simplify3d?

]]> https://www.soliforum.com/user/11160/ 2015-07-27T17:23:43Z https://www.soliforum.com/post/102141/#p102141 <![CDATA[Re: WARNING: Firmware unresponsive]]> Is this your first time printing this part  if so did you try sending through netfabb

]]> https://www.soliforum.com/user/9677/ 2015-07-27T16:56:45Z https://www.soliforum.com/post/102140/#p102140 <![CDATA[Re: WARNING: Firmware unresponsive]]> I start working from the PC, now I run from the SD card, I hope not to have the problem!

]]> https://www.soliforum.com/user/11160/ 2015-07-27T16:40:56Z https://www.soliforum.com/post/102138/#p102138 <![CDATA[WARNING: Firmware unresponsive]]> Hello
this is the first time I have this?


SENT: G1 X65.493 Y97.476 E20.1770
RECEIVED: ok 0
SENT: G1 X65.514 Y97.419 E20.1794
RECEIVED: ok 0
SENT: G1 X66.542 Y98.447 E20.2369
RECEIVED: ok 0
SENT: G1 X66.724 Y98.265 E20.2470
WARNING: Firmware unresponsive.  Attempting to force continue...
SENT: M105
SENT: G1 X66.909 Y98.135 E20.2560
WARNING: Firmware unresponsive.  Attempting to force continue...
SENT: M105
WARNING: Firmware unresponsive.  Attempting to force continue...
SENT: M105
WARNING: Firmware unresponsive.  Attempting to force continue...


it is stopped in the middle of work?

thx

]]> https://www.soliforum.com/user/11160/ 2015-07-27T16:24:42Z https://www.soliforum.com/post/102133/#p102133