SoliForum - 3D Printing Community — Eraser, First Scan

Re: Eraser, First Scan

2015-07-22T22:09:43Z

It looks like the camera calibration is pretty far off. Did you follow the calibration steps listed on http://www.murobo.com/start.html#calibration and http://www.soliforum.com/post/98712/#p98712? If so, navigate to the CAMERA page and place the calibration article in the proper place on the turntable (see http://www.murobo.com/start.html#calibration). Right click on the picture and click "Save Image As". This image will let us see what's off about your camera calibration.

Re: Eraser, First Scan

2015-07-22T15:54:02Z

I'm sorry I've been so slow in responding, summer got in the way :-)

Here is the eraser I'm trying to scan.

Re: Eraser, First Scan

2015-07-18T15:07:39Z

Kenny, can you post a picture of the object?

Re: Eraser, First Scan

2015-07-12T20:25:25Z

I just ran another scan of the same square rubber eraser. This time I used the default "High Resolution" setting that was preset in the scanning software.

This time it came out almost perfectly round.

Thoughts?

Thanks,

KennyB

Eraser, First Scan

2015-07-12T16:13:59Z

Thanks to the help from this forum I finally have my Atlas 3D up and running, that's the good news.

I calibrated it per the instructions and have it perfectly set up.

I scanned this with the right laser only. I set it to "5 meg still", 720 Frames, Laser threshold 3, Max Laser Width 80, Min Laser Width 5 and Binary Ply.

The bad news is that what came out looked nothing like the eraser I scanned. It was a simple 1" square rubber eraser.

I thought that would be a good first scan since it has no reflective surfaces and a simple shape. Unfortunately this is what I got.

Any suggestions would really be appreciated.

Thanks,

KennyB