<![CDATA[SoliForum - 3D Printing Community — cold extrusion]]> 2015-07-08T06:58:53Z PunBB https://www.soliforum.com/topic/11695/cold-extrusion/ <![CDATA[Re: cold extrusion]]> luc wrote:

try this one : M302 S<0 or 1> - allow cold extrusion. Without S parameter it will allow. S1 will disallow.

FYR: https://github.com/luc-github/Repetier- … petier.ino

Did not work for me, but never-mind, decided do just calibrate whit hot extruder, it just wasn't wort flashing the firmware for the calibration.

]]> https://www.soliforum.com/user/7943/ 2015-07-08T06:58:53Z https://www.soliforum.com/post/100636/#p100636 <![CDATA[Re: cold extrusion]]> try this one : M302 S<0 or 1> - allow cold extrusion. Without S parameter it will allow. S1 will disallow.

FYR: https://github.com/luc-github/Repetier- … petier.ino

]]> https://www.soliforum.com/user/8495/ 2015-07-07T09:17:32Z https://www.soliforum.com/post/100565/#p100565 <![CDATA[Re: cold extrusion]]> arturnoole163 wrote:

Ok thanks. I was hoping there is something like a gcode command I could use to temporarily enable cold extrusion.


Change has to be made at firmware level..

]]> https://www.soliforum.com/user/7731/ 2015-07-07T07:53:08Z https://www.soliforum.com/post/100562/#p100562 <![CDATA[Re: cold extrusion]]> Ok thanks. I was hoping there is something like a gcode command I could use to temporarily enable cold extrusion.

]]> https://www.soliforum.com/user/7943/ 2015-07-07T06:25:40Z https://www.soliforum.com/post/100561/#p100561 <![CDATA[Re: cold extrusion]]> arturnoole163 wrote:

Hi,

I'am running Da Vinci 1.0 with repetere 0.92 firmware. I'am in the process of converting it to Bowden extruder so I was wondering, is there a way to enable cold extrusion in repetere? It is really annoying that in order to test my E steps I have to first heat up the extruder and only then can I extrude manually from repetre host.

Your line in question: Line 955:

#define MIN_EXTRUDER_TEMP 170

]]> https://www.soliforum.com/user/7731/ 2015-07-07T05:55:33Z https://www.soliforum.com/post/100557/#p100557 <![CDATA[cold extrusion]]> Hi,

I'am running Da Vinci 1.0 with repetere 0.92 firmware. I'am in the process of converting it to Bowden extruder so I was wondering, is there a way to enable cold extrusion in repetere? It is really annoying that in order to test my E steps I have to first heat up the extruder and only then can I extrude manually from repetre host.

]]> https://www.soliforum.com/user/7943/ 2015-07-07T05:23:54Z https://www.soliforum.com/post/100556/#p100556