SoliForum - 3D Printing Community — Printer not heating up

Re: Printer not heating up

2015-07-06T20:09:10Z

http://e3d-online.com/Spares/Thermistor-Replacement-Kit

This is the actual sensor from an E3D this work before I just ordered a new one to see if that will work

Re: Printer not heating up

2015-07-06T06:00:48Z

you cannot use any thermistor on Davinci because it has additionnal resistor, so table need to be modified, it cannot be use as it is

http://voltivo.com/forum/davinci-firmwa … ruder#3631

Re: Printer not heating up

2015-07-06T05:21:58Z

And no this is running repertier 0.91

Re: Printer not heating up

2015-07-06T05:21:38Z

Yeah it's cold but reads 359 then errors out. It's a new sensor. If it happens with the E3D official one then I'm parting the machine out getting another different one

Re: Printer not heating up

2015-07-05T23:46:34Z

sensor defect, so you are in dry mode to avoid problem
if you said you read 359 when starting, because sensor has a limit of 300, over this temperature it consider the measurement has a problem, so it go to dry mode to prevent heating.
You also can connect repetier to see what temperature is measured, def is only on LCD
Looks like sensor problem, if at room temperature it give 359 degres, it is not normal

Re: Printer not heating up

2015-07-05T21:41:55Z

Is this a stock machine or modified? I don't remember what the stock LCD looks like.

Re: Printer not heating up

2015-07-05T18:51:33Z

I have since changed out the thermister twice and this time when i connect it it reads 359 and then reads def

Really don't know what to do and am getting desperate for help here

Printer not heating up

2015-07-02T14:00:30Z

I've come to heat my printer up to put filament in and it just says DEF next to the temps and is not warming up. Attached a picture to help people understand

Hope some one can help