<![CDATA[SoliForum - 3D Printing Community — display time remaining ?]]> 2015-06-27T00:35:26Z PunBB https://www.soliforum.com/topic/11614/display-time-remaining/ <![CDATA[Re: display time remaining ?]]> printing from Repetier host display printing progression / remaining time on printer LCD
printing from Simplify3D do not display printing progression / remaining time on printer LCD (at least until 2.22, no idea if 3.0 do it now)
printing from SD card display printing progression / remaining time on printer LCD

]]> https://www.soliforum.com/user/8495/ 2015-06-27T00:35:26Z https://www.soliforum.com/post/100017/#p100017 <![CDATA[Re: display time remaining ?]]> Just a note as well, the time remaining has an error rate of +/- 30 to 45 minutes as it is computed rather than tracked real time.

After checking, Repetier .92 should show time remaining but again that is estimated and is usually off by 20%.

I forgot I was running Marlin as I have converted to a RAMPS controller on my 1.0 so it was not showing time remaining nor do I really track it since it prints at night while I am asleep and when I am doing other things. When it gets done, it gets done.

]]> https://www.soliforum.com/user/7731/ 2015-06-26T21:37:10Z https://www.soliforum.com/post/100006/#p100006 <![CDATA[Re: display time remaining ?]]> For me, if you are on windows it will display it on the printer's LCD, I have a dual boot so I mostly stay on Mac which does not.

Besides I'm not one who dwells on the time remaining.  Start the print, make sure it's running good, then leave it.

]]> https://www.soliforum.com/user/8348/ 2015-06-26T21:03:10Z https://www.soliforum.com/post/100002/#p100002 <![CDATA[Re: display time remaining ?]]> OK thank you! print with its SD Card  possible?

]]> https://www.soliforum.com/user/11160/ 2015-06-26T20:50:50Z https://www.soliforum.com/post/99999/#p99999 <![CDATA[Re: display time remaining ?]]> Not with repetier firmware. It is displayed in the host however.

]]> https://www.soliforum.com/user/7731/ 2015-06-26T20:47:44Z https://www.soliforum.com/post/99998/#p99998 <![CDATA[display time remaining ?]]> hello,
it is possible to display the time remaining on the lcd of DaVinci 1.0?
if so how?
thank you

firmware repetier

]]> https://www.soliforum.com/user/11160/ 2015-06-26T19:41:15Z https://www.soliforum.com/post/99986/#p99986