<![CDATA[SoliForum - 3D Printing Community — s3d configured ?]]> 2015-06-24T08:53:30Z PunBB https://www.soliforum.com/topic/11590/s3d-configured/ <![CDATA[Re: s3d configured ?]]> First of all, your Extrusion Width is set to 0.50...it should be 0.48; then follow the steps outlined here:

https://solidoodletips.wordpress.com/20 … flow-rate/

The above was done for a 0.35 dia. nozzle, but the calculations / adjustment procedures are the same...

]]> https://www.soliforum.com/user/131/ 2015-06-24T08:53:30Z https://www.soliforum.com/post/99800/#p99800 <![CDATA[Re: s3d configured ?]]> 1.10 works well for me.

]]> https://www.soliforum.com/user/6872/ 2015-06-24T07:10:51Z https://www.soliforum.com/post/99798/#p99798 <![CDATA[Re: s3d configured ?]]> IronMan wrote:

Seems like you are under-extruding a bit...try bumping up your Extrusion Multiplier...

Also, you should do a single-wall calibration cube every time you switch filament.

I have 1,0 I need to increase maximum how much?

]]> https://www.soliforum.com/user/11160/ 2015-06-23T22:25:22Z https://www.soliforum.com/post/99765/#p99765 <![CDATA[Re: s3d configured ?]]> Seems like you are under-extruding a bit...try bumping up your Extrusion Multiplier...

Also, you should do a single-wall calibration cube every time you switch filament.

]]> https://www.soliforum.com/user/131/ 2015-06-23T20:49:08Z https://www.soliforum.com/post/99753/#p99753 <![CDATA[s3d configured ?]]> hello, I use S3D shoulders and neck not very well printed, how well configured? thank you

attach FFF setup s3d

]]> https://www.soliforum.com/user/11160/ 2015-06-23T19:59:35Z https://www.soliforum.com/post/99749/#p99749