<![CDATA[SoliForum - 3D Printing Community — Davinci 1.0 parting out. has upgraded pico b3 head]]>2016-03-22T19:09:21ZPunBBhttps://www.soliforum.com/topic/11574/davinci-10-parting-out-has-upgraded-pico-b3-head/<![CDATA[Re: Davinci 1.0 parting out. has upgraded pico b3 head]]>i need the front stepper motor is the one says 17pm-k142bp03cn. but not the rear of this as it is to long. they are different sizes even though they have the same numbers. so if you have this it measures 38mm length by 42 width 42 depth. if you do have it i will take it tell me how much you want and your paypal. thanks]]>https://www.soliforum.com/user/14023/2016-03-22T19:09:21Zhttps://www.soliforum.com/post/119735/#p119735<![CDATA[Re: Davinci 1.0 parting out. has upgraded pico b3 head]]>Hi there, don't suppose you still have the motherboard do you ?
Thanks
]]>https://www.soliforum.com/user/13283/2016-01-15T14:56:42Zhttps://www.soliforum.com/post/114175/#p114175<![CDATA[Re: Davinci 1.0 parting out. has upgraded pico b3 head]]>Looking for the led bar (that lights up the inside)....]]>https://www.soliforum.com/user/13164/2016-01-05T19:40:27Zhttps://www.soliforum.com/post/113339/#p113339<![CDATA[Re: Davinci 1.0 parting out. has upgraded pico b3 head]]>I'm looking for a Z axis sensor.]]>https://www.soliforum.com/user/8650/2015-08-24T11:56:32Zhttps://www.soliforum.com/post/104105/#p104105<![CDATA[Re: Davinci 1.0 parting out. has upgraded pico b3 head]]>Do you have an x axis connector? I have a 2.0 and am not sure if it's the same piece. I've attached a pic of what I need.
]]>https://www.soliforum.com/user/11461/2015-07-14T18:03:23Zhttps://www.soliforum.com/post/101110/#p101110<![CDATA[Re: Davinci 1.0 parting out. has upgraded pico b3 head]]>hello, you have shaft Y davinci 1.0 ? 2x thx]]>https://www.soliforum.com/user/11160/2015-07-07T19:57:51Zhttps://www.soliforum.com/post/100586/#p100586<![CDATA[Davinci 1.0 parting out. has upgraded pico b3 head]]>Parting out my davinci 1.0 has upgraded pico B3 head. my main PC board went bad. Rather just make a new printer from scratch. PM me if you want any parts thanks]]>https://www.soliforum.com/user/7268/2015-06-23T02:25:38Zhttps://www.soliforum.com/post/99692/#p99692
