SoliForum - 3D Printing Community — Stepper motors will all pause. normal or not?

Re: Stepper motors will all pause. normal or not?

2015-06-23T02:16:51Z

Just tested it with the SD card and it does not pause. works great. Maybe I will just use that way. I just downloaded a app also that I can use my tablet with it.

Re: Stepper motors will all pause. normal or not?

2015-06-23T01:48:36Z

ok thanks

Re: Stepper motors will all pause. normal or not?

2015-06-23T00:33:43Z

hansen644 wrote:

So up it to 25000?

Thats what my Da Vinci RAMPS runs at.

Re: Stepper motors will all pause. normal or not?

2015-06-22T23:39:12Z

So up it to 25000?

Re: Stepper motors will all pause. normal or not?

2015-06-22T22:41:17Z

hansen644 wrote:

Live print. I have not tried SD card yet to compare. Would I have to change the baud rate in my firmware or ? I am running 115200 baud now.

You change it in the firmware configuration.h tab and in your host.

Re: Stepper motors will all pause. normal or not?

2015-06-22T22:38:48Z

Live print. I have not tried SD card yet to compare. Would I have to change the baud rate in my firmware or ? I am running 115200 baud now.

Re: Stepper motors will all pause. normal or not?

2015-06-22T22:23:19Z

Is during a live print or from an sdcard? You could try raising your baud rate.

Stepper motors will all pause. normal or not?

2015-06-22T22:17:12Z

Hi I have a smartone 200 printer I just built and it is working good but I the machine will pause at times for about one full second then keep going. Is that normal or a stepper overheating or something?