<![CDATA[SoliForum - 3D Printing Community — original solidoodle 3 extruder]]> 2015-06-12T14:55:32Z PunBB https://www.soliforum.com/topic/11411/original-solidoodle-3-extruder/ <![CDATA[Re: original solidoodle 3 extruder]]> If it doesn't thread in snug you most likely need to increase your extrusion a little.

]]> https://www.soliforum.com/user/2291/ 2015-06-12T14:55:32Z https://www.soliforum.com/post/98750/#p98750 <![CDATA[Re: original solidoodle 3 extruder]]> Lawsy said :Move the bearing, washers and bolts over to the new tension arm. I prefer one washer at the front of the bearing and three at the back for better alignment. A M3 x 16mm bolt is a perfect length to secure the tension arm to the body.
can i use the same bolt that comes out from my bearing setup?
the other end of that hole doesn not grasp the bolt and it moves freely .

]]> https://www.soliforum.com/user/8264/ 2015-06-12T14:22:23Z https://www.soliforum.com/post/98747/#p98747 <![CDATA[Re: original solidoodle 3 extruder]]> http://www.thingiverse.com/thing:111213

]]> https://www.soliforum.com/user/4188/ 2015-06-06T23:36:41Z https://www.soliforum.com/post/98178/#p98178 <![CDATA[original solidoodle 3 extruder]]> ok so i've been tryign to set my pritner back up and the screws i have to use won't fit the original puzzle end they shoul dbut they don't sigh. so i need a replacement for the original puzzle end.

which is the best one to use on thingiverse?

]]> https://www.soliforum.com/user/168/ 2015-06-06T23:19:53Z https://www.soliforum.com/post/98177/#p98177