I decided to cut the old thermistor cable and connect them like you see in the picture below. The thermistor seemed to be giving accurate temperature readings and so I started putting it back together but I overtightened the set screw and broke the wire again. Off to rewire it again with a new thermistor...
Moral of the story, Don't over-tighten the set screw!
]]>I contacted Solidoodle support about this and they told me they could send one for $35.75 including shipping (east coast USA) which just seems insane to me.
chenderson wrote:Drop in replacement, no firmware changes required.
How did you physically connect this to your printer? I don't currently have access to a soldering iron...
I had to solder my thermistor in and use heat shrink tubing to cover it. I would suggest picking up a soldering iron, watch some youtube videos, and practice. It is a very useful skill to have when owning a 3d printer. $35 is a scam, especially considering the $3 one from ebay is 100% identical physically and functionally to the solidoodle one. The labeling on the wiring is even the same.
]]>I contacted Solidoodle support about this and they told me they could send one for $35.75 including shipping (east coast USA) which just seems insane to me.
Yes, that's price gouging, since the similar item for the SD4 is $10, not $30. (wire length and connector are different). Feel free to call them out on this on their FB page.
]]>Drop in replacement, no firmware changes required.
How did you physically connect this to your printer? I don't currently have access to a soldering iron...
]]>How would I go about changing the firmware to a different resistor?
Download the firmware sources from the SD support page, unzip, and in configuration.h, modify the definition of TEMP_SENSOR_0 on line 145 to select the thermistor of choice. (read the comments in the fiile) Then build and flash. MacgyverX's topic on this, or the Marlin firmware support pages would have better directions than I could hope to give (My Press is pretty much stock. I have my own printer project to experiment on. 
)
Here is a link to the one I purchased for my press. Used them for both extruder and bed. Drop in replacement, no firmware changes required.
Nice & cheap. Did you find the beta, or verify the resulting temp? Also, idealy you'd crank down the max temp in the firmware, as that seems to be rated for only 270, and the Press limits to 280. (No fun having a typo destroy your rig.)
]]>Did I purchase the correct thermistor?
]]>I just found a short in mine too. From this thread it sounds like the thermistor may be a Semitec 104GT-2. It looks similar but thermistors all look the same to me.
I don't believe that is a drop-in replacement. That thread was really discussing the E3D thermistor.
The stock Press firmware uses Marlin firmware table 1 (for Epcos 100k). To get accurate temps with the 104GT-2 you'd need to recompile/reflash the firmware configured with table 5.
Soliwiki claims Epcos B57540G0104F000 is compatible for SD printers as of 2103, but that obviously predates the Press. That part uses table 1, so it would be plausible for the Press. (http://www.soliwiki.com/List_of_compatible_hardware)
]]>I just found a short in mine too. From this thread it sounds like the thermistor may be a Semitec 104GT-2. It looks similar but thermistors all look the same to me.
Thanks
Rob
Just order them up from filastruder.
I saw themin there but there a couple of different types?
Thanks
Rob